Russound SIX-SOURCE CONTROLLER CAM6.6T Uživatelský manuál stáhnout pdf (Strana 9)

9 of 9

COMMON MISTAKES

1. Forgetting to switch the RS-232 selector switch on the front of the CAV6.6/CAM6.6 to “Front / Rear”.

2. Improper programming of the CAV6.6/CAM6.6. Make sure you complete programming of the

Russound equipment, and that it functions properly as a stand-alone system, before attempting to

connect and control from the ELAN system.

3. Improper firmware versions installed on the CAV6.6/CAM6.6, the Uno keypad, or the ST2 tuners.

Due to various enhancements (such as the XM radio, the release of the SMS server, etc.), Russound

has changed the firmware of the devices. Consult the table above, and make sure your versions

match one of those listed.

4. Improperly setting the Controller Numbers for systems with multiple CAV6.6 units. Remember to set

the Controller Number for the first CAV6.6 to 1, the second to 2 and so on. The Controller Number

must match the corresponding Controller Number set for that CAV6.6 in the Configurator.

5. Improperly setting the RNet IDs for ST2 tuners. Each ST2 has two tuners, and each has a Tuner ID.

The Tuner ID must match the corresponding source number in the CAV6.6/CAM6.6, and must be

correctly entered in the Configurator.

6. Programming the Russound while it is connected to the ELAN controller. There may be some odd

behavior if the Russound system is programmed while connected to a ELAN controller.

1 2 3 4 5 6 7 8 9

Žádné komentáře

Russound SIX-SOURCE CONTROLLER CAM6.6T Uživatelský manuál Strana 9