Source Setup - Source Setup Procedure Basics
The S
ource Setup procedure is used to assign source numbers, and
command types for IR learning and IR device codes. Below are the
primary source setup steps.
ON
OFF
AL
L
OFF
DISC
SLEEP
ZONE
A-SRC1 Remote
Control buttons
Press and RELEASE Setup button.
Aim A-SRC1 remote control 2 inches away from IR In
Enter source number (S1 to S6)
Source/Test (green) blinks # to match source #
ON
OF
F
AL
L
OF
F
DISC
SLEEP
ZONE
5.
6.
7.
8.
Source/Test (green) turns ON
Cmd/Type (yellow) blinks SLOWLY
Device Code
01 - 11
(page 28)
Le
arn IR
99
(page 29)
Invalid Entry
##
(page 31)
Clear Code
s
00
(page 32)
Proceed to page listed below for each procedure
Source/Test (green) turns OFF
Komentáře k této Příručce